-
Hello there, i found your code trying to figure out a way to read data from my jkbms. It has hardware 11 and AFAIK it supports 32 cells the output changed a bit. my current output is this, what do you…
-
I have JK-BMS with bus serial battery install. At the moment I'm testing on the bench with single BMS which data (battery voltage, current, temperature, etc) I can see on the Venus OS (running on RPI4…
-
Hi,
In my setup I have two JK BMS using dbus-serialbattery driver and a CAN-BUS BMS for which I do not need dbus-serialbattery as it is directly recognized in Cerbo GX. Does dbus-aggregate-batterie…
-
### Describe the bug
**My Setup**
Victron Cerbo GX
Victron MPPT 250|100 Solar Charge Controller
Victron Multiplus-II 48/5000/70
Battery 1 - 280AH x18s LiFePo4, Daly 150A BMS, Parralel protection…
-
### Describe the problem
I have a persistent and repeating "low battery"alarm. I have no clue where it comes from, as I see no registration of any voltige even near the warning and alarm tresholds …
-
### Describe the problem
I tried 1.4 and 1.5 stream today and got
```
2024-09-29 05:39:50.324117500 INFO:SerialBattery:Testing Seplos at address "\x00"
2024-09-29 05:39:50.325701500 DEBUG:Seri…
-
Registries 5018-5021 report in .1C, so 80 would be 8C
Registry 5103 is the status of the battery heater. 0-255 (0 being off, 255 being on-high) Not sure on the intermediate values but it shuts off at…
-
### Describe the bug
I run 4X300Ahr 12V batteries with 4X JKBMS in parallel. they are connected to the RPI running Venus OS via 4 X RS485 to USB.
it is been running fine with no issues with the occ…
-
### Describe the bug
I am having a setup with 6 EG4 lifepower batteries. They are dipswitched 1 till 6 (verified via BMS Test program).
Only the batteries 1, 3 and 5 are successfully read by dbus-…
-
### Describe the bug
The mapping between the labels on the physical temperature sensors and the IDs reported by dbus-serialbattery is wrong.
On the BMS balancer wiring loom (in my case, PB2A16S20P…