-
### Synopsis
Reduce DCC-EX's half-bit transmit duration for "1" to **54** µSec (or at least **55** µSec).
### Background
As described in the [High Accuracy Waveform Mode documentation](https://…
-
The NMRA spec says that "C" below is activate/deactivate and the X in DDX handles which pair of outputs and the DD specifies which of the 4 outputs is being controlled. But... some decoders can allow …
-
Trains not physically on the tracks are sometimes reported by the hardware as being detected, e.g., by MSG_BM_SPEED and MSG_BM_ADDRESS.
-
Before asking my obvious question, I want to thank you from the bottom of my heart for your work! You and your whole team are super people! You are doing a good and necessary thing! Thank you! Now the…
-
If I put my loco on track without register the address and then try to run it, I suggest that the headlight turns on and off, on and off, ..., some time, for example 10 times. That would show me that …
-
wiThrottle should support DCC decoders with 28 speed steps.
There should be a selection after the DCC address with at least the options "128", "28" speed steps.
May be this could extended to all o…
-
I see a lot of idle packets, but it doesn't seem to decode accessory packets. It doesn't see the preamble which is there, so it never starts the decoding process I'm not sure if it is related, but I d…
-
This bit of code really isn't necessary—CmdrArduino runs, effectively, in a background thread. So long as you call `dps.update()` at the end of every loop, there is no need to send function and speed …
-
## Description
When a parser receives an EXRail response
I want to parse the response into usable elements
so that I can perform other tasks with the information
## Design
EX-Rail responses are…
-
Hi!
Erst einmal vielen Dank für Deine Arbeit!
Da ich zur Zeit nur Weichen steuern möchte, habe ich versucht mehr als 4 Weichen einzutragen, leider klappt das nicht.
`const byte iniTyp[] = …