-
Add support for msm8996
(Xiaomi mi 5, Gemini)
-
Hi,
I am attempting to use a D435i camera on my Jetson Orin NX with JP6.0. I was directed to this [this page](https://github.com/IntelRealSense/realsense_mipi_platform_driver) to install the MIPI d…
-
I hooked up a known working screen (Waveshare 4.3inch, works fine with FlyOS without any configuration), but there's no output when I boot this version of Armbian. Do I need to do anything specific to…
-
Hello,
I'm trying to work out if I can turn an LED on when a board is being flashed and turn it off when it has finished. I was thinking of using the pre and post install scripts and raspi-gpio …
-
Hello,
I came across your Guide to using a TPM 2.0 module on Khadas VIM3.
I'm trying to do the same thing but on a Khadas Edge V.
I have no particular knowledge of linux kernel and hardware and hav…
-
There are some open questions and possibly overlapping design proposals on how we integrate modules involving kernel patches and device tree configurations into Ghaf.
In the current main branch the…
-
[hades32] To make the camera module work you currently have to
```
wget http://goo.gl/U4t12b -O /mnt/boot/dt-blob.bin -O /mnt/boot/dt-blob.bin
```
And then set these variables in the Fleet Configurat…
-
First issue, I'm getting Low Voltage warning when I plug this in using the CanaKit power supply. This is immediately a return item simply based on that.
Second issue, this thing is heating up well …
-
I am trying to get started with the CRAMPS tree overlay. My kernel version from /boot/uEnv.txt is `uname_r=4.19.94-ti-r42`
When I run sudo` ./start-devicetree-overlay.sh CRAMPS/BeagleG-CRAMPS.dts`…
-
Good morning,
I'm trying to boot Proxmox on Mixtile Blade 3 using the 8.1-7 ISO, but it's getting stuck here.
I'm using the latest UEFI boot, and I've set Config Table Mode to Device Tree and I've…