-
### Bug Description
Example configs for bugfix-2.1.x all contain the following in Configuration.h
```
/**
* Add Z offset (M424 Z) that applies to all moves at the planner level.
* Thi…
-
Hi, I don't know why all the tutorials I saw on the internet about using Dwin displays don't deal with CRC error control.
It is very important to have error handling in noisy environments, especial…
-
Hi everyone, I would like to know if is it possible to connect the display on the board mentioned on the title and how eventually.
Because I canot find the RX1 and TX1 pin on the scheme of the board n…
-
Hey Guys,
is it planed to integrate Spoolman in the project?
maybe a mask which shows the Spools an a button to change the actual spool?
greetings from Austria
Mike
-
-
Hey.
I would use the Vyper Display with Klipper.
I connected the Display directly to the Raspberry Pi 3b+ GPIO Pins.
My Raspberry often gets undervoltage messages no matter which power supply I…
-
Не запускается на skr e3 dip. После запуска только логотип MKS. Как решить проблему?
-
Hello,
Is this firmware used for S1 Pro as well?
Regards,
Ayush
-
-
hi, impossible to put you screen firmware in my screen, i have the blue screen, i have the "end" message and when i restart my printer there is my ui who is always on it. i ve tried with the two dwin_…