-
I have a landis gyr e220 power-meter that sends binary data over IR which I learned is SML protocol. I thought this project could do the decode but I can't see how to use it.
The example doesn't run …
-
### What happened?
Hello Everyone,
I have 4 Eufy Cameras at my home, where on is a native Homekit Camera (Indoor Cam E220) and the other 3 are normal Cameras:
Outdoor Cam E210
eufyCam 2C Pro
Vide…
-
There seems to be a problem with RegIrqFlags, which causes problems in **LoRaSimpleGateway** and **LoRaReceiverCallback** example sketches. The following is far beyond my knowledge, so please bear wit…
-
```
Hareware: Devkit8k
Software: Eclair R4
Modem: HuaWei E220 USB 3G modem
What steps will reproduce the problem?
0.Config the latest kernel of 0xlab to enable PPP driver and
CONFIG_USB_SERIAL_OP…
-
Looks like citations are still a little garbled.
I don't remember what exactly it looked like prior to PR #377, but looking at it now (e.g. https://alpha.physionet.org/content/mitdb/1.0.0/), I see:
…
-
**Describe the bug**
Turning on Light switch, the camera's light goes on briefly, then turns immediately off, while Light switch in HA remains on.
**To reproduce**
Steps to reproduce the beha…
-
The light mode is not themed and does not look very good. it should be disabled.
-
My program has been working and suddenly stopped. The cause is updating ESP32 board manager from 2.017 to 3.0.0 on Arduino IDE 2.32.
Since new ESP32 board manager is based on ESP-IDF v5 and I know a…
-
### What happened?
Hey there! Not sure if it's a "bug," but neither my Homebase (S380) nor cameras are showing up after successfully logging in using the correct country. I receive the message "No st…
-
### Problem description
Sublime Text supports a wide range of different text decorations (even some very exotic like glow text), but unfortunately, it doesn't support strikethrough text either in t…