-
I barge in just to provide an idea for future development.
In #2610 a design using a magnetometer is provided which would allow extremely high measurement accuracy (potentially microns of filament …
-
As a filament detection sensor, the proximity sensor was purchased as an NPN NO type and the filament detection was reversed.
Is there any way to use this sensor now by modifying the firmware?
If so…
-
Hi, I hade few issues in just 2 days (frustrating) when I had to disassemble hotend, after I ran out of filament on the spool. Now it works like this:
1. Filament runs out - good
2. First sensor is …
-
Since a firmware update I no longer detected the end of the filament, when I received my BTT TFT 35 E3 screen, I updated the screen and the firmware of the SKR Mini e3 V1. 2.
I didn't notice it right…
-
from octoprint Log:
2016-09-01 15:53:54,607 - octoprint.plugins.filament - INFO - Running RPi.GPIO version '0.6.2'...
2016-09-01 15:53:54,610 - octoprint.plugins.filament - INFO - Filament Sensor Plu…
Werja updated
7 years ago
-
Hello,
Im using repetier firmware 0.92.9 with filament jam detection on. The printer itself works fine, but sometimes has some Z-axis issues. At random height it just suddenly stops. The other 2 axes…
-
Hello!
I recently purchased a BTT SFS v2.0 and I have a Creality v4.2.7 system board. The manual says, “To connect to a motherboard without filament runout port, please consult our technical suppor…
TacII updated
2 weeks ago
-
At this moment we only have a filament out detection.
We would like a filament jam detection. We used repetier firmware in the past and the way that handled filament jam was very usefull:
It compa…
-
Future Request: Operation upon stopping at filament detection
Since there were no objections to my suggestion in the Snapmaker forum, I would like to make a feature request for the following
For…
-
This must be an oversight - MMU_TEST_TRACKING raises the servo after the initial 100mm load before stepping 1mm at a time to verify encoder/filament tracking. The servo should be engaged for the durat…