-
**Printer type** - MINI
**Printer firmware version** - 5.1.0-alpha2
**Original or Custom firmware** - Original
**Optional upgrades** - Filament Runout Sensor
**Describe the bug**
Cancelli…
-
Firmware: 1.0.5beta
Currently the filament runout sensor only works for prints from SD card. Octoprint cannot detect runouts.
I don't know much about GCODE but it seems that the M115 command gets …
-
The instructions say to invert the FIL_RUNOUT_INVERTING = TRUE. But that's no longer supported and only FIL_RUNOUT_STATE Low/High is supported.
I've tried both high and low, and whenever I start…
-
Hello!
I recently purchased a BTT SFS v2.0 and I have a Creality v4.2.7 system board. The manual says, “To connect to a motherboard without filament runout port, please consult our technical suppor…
TacII updated
3 months ago
-
The filament detection sensor keeps triggering for a filament change I've tried inverting the sensor, raised the run out distance but it still happens. I'm using an Skr 1.4 Turbo board and it's plugge…
-
Dear all,
Steps to reproduce:
Enabled filament sensor in Features menu and start a print job.
It causes a false positive (the light in the sensor works correctly changin from red to green).
The co…
-
Hey just a small update for the Klipper N3P config. The filament sensor type appears to be a switch instead of a motion sensor. It kinda works as-is but it usually pauses the print right at the begi…
-
If it makes sense, enter what type of printer or upgrade the feature request applies to.
**Printer type** - XL
**Is your feature request related to an existing problem? Please describe.**
When th…
-
HI
Can You compile for a Ender 3 a Firmware with BLTOUCH and RUNOUT FILAMENT SENSOR please?
If possible with Fotos where the Runout Filament sensor install must (Wich PIN in Mainboard)
Thanks
-
Hi, can you help me please?
I have no idea to which connector on the sb2209 board I can connect filament sesor which I have in the tool head Stealthburner.
Thank you so much