-
### Board
esp32
### Device Description
esp32 wroom3d devkit v1
### Hardware Configuration
gpio pins 21 connected to sda and 22 to scl, issue occured during testing of mcp3424 adc module
### Vers…
-
### Describe the bug
As per discussion in #13696, there appears to be an issue with the F435 from iFlight and connecting mag sensors to the I2C bus. My issue has only been the mag not connecting bu…
-
### Target name(s)
ESP32_C6_THREAD
### Firmware version
all versions
### Was working before? On which version?
none
### Device capabilities
_No response_
### Description
There is an issue at …
-
Booting the GL-AR750, I can see that the gpio-based I2C controller is set up with the expected pins 16 and 17:
```
[ 0.147948] gpio-17 (sda): enforced open drain please flag it properly in DT/ACP…
-
I have a feature request that will help while connecting and coding **I2C devices**.
Often times I face the issue that I don't know the **I2C Addresses** or if a Device is fully utilized and detec…
-
### Question
I have gotten the sleepy end device code to work on my ESP32H2 - however, I cannot use a led driver (connected via i2c) after the board wakes from sleep. Is there a lock that I need to …
-
### Describe the bug
The i2c bus fails to detect and communicate with connected i2c devices. Dmesg output:
[ 1.878285] i2c_dev: i2c /dev entries driver
[ 2.368416] brcmstb-i2c 107d508200.i2c:…
-
Hello,
I am spending a lot of time getting this device working with esphome. My whole esp ecosystem has moved from platformio to esphome because it is so much more simple and powerful to get stuff g…
-
[ 0.000000] Booting Linux on physical CPU 0
[ 0.000000] Initializing cgroup subsys cpu
[ 0.000000] Linux version 3.4.0-perf-gc02987471fb (guaiyihu@DESKTOP-98UUC2O) (gcc version 4.7 (GCC) ) …
-
Power:
- [x] Check for short circuit on VBUS rail
- [x] Check for short circuit on 3.3v rail
- [x] Power device via USB without battery attached
- [x] Check 3.3v rail voltage
- [x] Check 2.5v sta…