-
https://robotzero.one/esp32-mpu9250-three-js/
https://github.com/aster94/SensorFusion/blob/master/src/SensorFusion.h
https://github.com/jrowberg/i2cdevlib/tree/master/Arduino/MPU9250
https://www.in…
bymse updated
2 years ago
-
Dear Jeff,
I'm currently using MPU6050_6Axis_MotionApps20.h and it works OK. However I need 9Axis. The 4.1 9Axis version looks quite old. The newest 6.1 is also only 6Axis.
Any plans, updating the 9…
-
Hi,
So i wanted to contact you about features i'd like to contribute and maybe discuss this in advance so its clear on how you might want these added. I have quite alot of experience with these IMU…
-
Hi,
Nice work on your Java library of sensors. You may be interested in the ones I have written for my own [Java device I/O library](www.diozero.com).
See:
- https://github.com/mattjlewis/dioze…
-
Hello everybody
On the page 7 the MPU Hardware Offset Registers Application Note, it is written about accel offset
_Bit 0 on the low byte of each axis is a reserved bit and needs to be preserved_…
-
May I ask that is there any better way to calibrate the magnetometer?
I have tried to do the figure 8 calibration, but the result can only depends on your luck.
is it the problem of my skill or it i…
-
Magnetometer (HMR2300-D21-232): (I think it is dropped out on 9/9/2021)
IMU (Analog Devices ADIS16400BMLZ): (I think it is also dropped out on 9/9/2021)
GPS (NovAtel OEM-719)
Sun Sensor (FSS10…
-
Please tell me, what will it be necessary to do to seal the work of EDTracker with the ICM-20948 sensor (is it positioned as a replacement for MPU-9250)? Is it possible?
-
Currently the magnetometer can only be used in bypass mode. This means you can't use two MPUs on the same bus - even though you can change the address of one of them using AD0, their magnetometers sti…
-
```
What steps will reproduce the problem?
Set MPSSE to Ack following each read byte.
Perform an I2C Read followed by a Stop. The number of bytes read doesn't
matter.
What is the expected output? W…