-
Hi,
The following attributes are missing in the resource iosxe_interface_tunnel.
In the context of ipsec protected tunnels these are important.
ip mtu 1400
tunnel vrf X
kind regards
-
Hello, please I need help, I have set up an IPSEC tunnel between 2 Amazon AWS accounts with Libreswan 4.12.
Tunnel is up and running, but network traffic inside the tunnel goes only from one end to t…
-
In the per-tunnel key system, the `ipsec-key-rotate` action currently assumes a [fixed number](https://github.com/cilium/cilium/blob/a6b8538908f448a962e19730c6a34ece7c1caa81/.github/actions/ipsec-key-…
-
Once https://github.com/cilium/cilium/pull/31082 has landed, we should test that there's no regression in this area.
A reasonable check would be run a test (similar to `no-ipsec-xfrm-errors`) that …
-
**What would you like to be added**:
Multiple active gateways for higher inter-cluster data transfer performance.
**Why is this needed**:
Currently there is only one gateway per cluster. As p…
-
Enhance the troubleshooting section to help people figure out conditions in which the tunnels are shown as down but IPSEC is up. This may be due to BGP not being established across both tunnels.
-
Hi,
I want to know if it's possible to have a add a new feature with the mode IPSEC, infact the plugin is working but it displays only active current tunnel withnthe phase 1 and if the tunnel is n…
-
Terraform will perform the following actions:
```
# fortios_system_interface.internal will be updated in-place
~ resource "fortios_system_interface" "internal" {
id …
-
Since that's what IKEv2 calls it.
-
great job man.
i tested and work ok.
the ip status status not work correctly and the phase 2 result disconnect but is connect. 0= disconnect 1=connect
you make a trigger for a tunnel status?