-
I can work with this, but was wondering if it was normal.
BrickPi3, ev3dev, lejos, lego-ev3-gyro sensor, I’m getting odd readings. I was expecting degrees, but instead get 0-255 as I tilt the senso…
-
Hello,
I am working with EV3 lego sensor connected with Brickpi3. The Brickpi3 is stacked on the GPIO pins of Zynq board and the lego sensor connected with brickpi3. The Brickpi3 and Zynq board commu…
-
I am trying to get my large Lego Mindstorms motors (``lego-ev3-l-motor``) to work with my BrickPi3 but I'm having some issues. I understand that by default ev3dev sets the motor ports to be NXT driver…
-
I'm trying to use an XG1300L gyroscope attached to my EV3, but I'm not able to get it working in my C++ program. I'm looking for help getting it to connect. I assume I've just missed a simple step, bu…
-
Hi,
With the new uf2 pack(#15) command it is my understanding that you can upload and run an UF2 file from makecode.org directly on an EV3, but I have somehow failed to understand the steps. I try…
-
I expected to use Scrub to control EV3 on iPad since we can't use Scratch Link on it.
Scrub said "this extension is not supported" when I tried to connect EV3.
I hope Scrub supports EV3 if the impl…
-
### Expected Behavior
We can use [45509 EV3 Infrared Sensor](https://shop.lego.com/en-US/EV3-Infrared-Sensor-45509) in Scratch 3.0 EV3 extension.
Although [5003400 LEGO MINDSTORMS Education EV3 …
-
## **What are you trying to do?**
Open Roberta Lab display values
## **What did you expect to happen?**
Able to quit program normally
## **What actually happened?**
Ev3 is stuck in the progra…
-
Hello, everyone! I'd really appreciate if someone could assist me with this little issue I ran into.
**What are you trying to do?**
I have a mindsensors.com EV3SensorMUX connected to a robot with …
-
Dear Klutzy,
Thank you for this amazing extension. I'm doing a project for the contest of FLL 2019 with EV3 micropython. But I am confused that EV3 micropython currently released is not supporting …