-
Hello together,
i'm sometimes faced with the following issue:
```
28.08.2023 08:18:23,683 - MainThread packet printInfo [INFO ] [pocsag]
28.08.2023 08:18:36,865 - Mai…
-
Would like to see as a future feature, the pager decoder module updated to support other protocols besides POCSAG, as many of the pager systems in my area (Australia) besides being POCSAG, also run on…
-
Rpi-tx pocsag is great, but it`s messy , even with filter. If we had a dedicated pin we can setup for output the POCSAG signal , we can connect a module like a HopeRf module to call our pagers. Thank …
-
i would like to see if these could be stored in a file or log that i could grep to find a certain page. i know i could listen to the freq with an sdr and decode the RF but if i could just see in real …
-
In order to test receivers, I suggest to change randomly some bits, especially for the **POCSAG** transmitter.
Could be useful to check software receivers like [multimon-ng](https://github.com/EliasO…
pyrog updated
3 years ago
-
Hello,
Current code is strongly dependent on sockaddr_in and limited to IPv4 support.
I am trying to rewrite with sockaddr_storage to add IPv6 support.
There is a modified code at https://github.…
-
Hi all,
Is there a way, or can there be a way, to specify the desired baud rate for local POCSAG paging?
Best,
Chris
-
You seem to have support for POCSAG, any chance we can get FLEX support?
Pyr3x updated
5 years ago
-
Requires adding the ability for apps to request a switch. Could also be useful for the scanner: open POCSAG receiver on signal detection, ...
-
Hi Kristoff,
Have you thought about implementing an RX feature? I'm considering doing this for DapNET, as an alternative to commercial pagers...
Regards,
Manoel - ON6RF