-
Great project!
Now I want the data to be nicely visible in the energy dashboard, where the PV battery and electricity are.
There is only a spare slot for 'Gas' (there are other posts elsewhere…
-
**Describe the problem you have/What new integration you would like**
PID Climate combined with `slow_pwm` can result to run and off times which are very short. The PID algorithm makes too fast d…
-
I would like to be able to see how much power is used by a print. That's all.
-
as Door need to be open and sensor beep when heating which slow down the process and is anoying
-
Hello,
randomly I get the following error message. I use knutwurst custom firmware 1.5.3
I use a Anycubic MEGA X printer.
What could be the reason?
**Heating failed, system stopped! Heater_ID:…
anno0 updated
4 months ago
-
UPDATE 27 Aug 2021 - Separate PID RANGE values coming soon. Meantime, good advice from thinkyhead on how best to mitigate this issue on the upstream bug [BUG] "Heating Failed" after PID takes over Mar…
-
I just noticed that my system was heating even when no zones were asking for it. I'm using a Nest, and Better Thermostat. `zoned-heating` is set to control the underlying TRV entities.
I'd previous…
-
**First of all, thank you for this library. It is really a piece of art.**
Probably Iam just **stupid** and can't use it properly.
**My setup**
- ESP32-Wrover-E ( 16mb flash, 8mb psram )
- Ardui…
-
Hello,
I have a problem with the heating of the nozzle and the bed of my ender 3 pro. Whenever I put the printer to heat both elements a the same time she starts the process and 5 second later it …
-
Hello,
I cant`t access data of a heating system with bacnet using thingsboard-gateway.
When I use Yabe, I can accesss all the things I want to know.
But when requesting data with thingsboard-g…