-
When I send packet which have enabled ACK. GW will reboot itself with panic error
ESP32, latest master
SF12, channel 0
```
--------------------------------------
M readUdp:: PKT_PULL_RESP r…
-
Hello all, i would like to thank the author of this library it’s supper easy to use without any complexity, so now i have two questions one is instead of setting a specific DataRate like lora.setDataR…
-
I have SX1278 LoRa module and RAK831 LoRa Wan Gateway. (433 Mhz). Will this library work with 433Mhz hardware? I can't see 433 Mhz frequency to select in config file from where you can select your reg…
-
I am using a raspberry pi 3 and RAK831. This is almost the same with RAK2245 so I just selected RAK2245 on the gateways. My gateway is EU868.
I followed the instructions and I got it working on TTN…
-
Hi, thanks for the new stack. I wanted to migrate away from the old udp-forwarder and tried basicstation, but it turned out that it only supports SPI communication and not the SPI over USB versions of…
-
I am using a raspberry pi 3 and RAK831. This is almost the same with RAK2245 so I just selected RAK2245 on the gateways. My gateway is EU868.
I followed the instructions and I got it working on TTN…
-
Hi! How can I use this software to read (and then send) raw Lora messages on my RAK831 Gateway?
Thanks in advance!
-
In the journal `journalctl -u lora-gateway-pf` I see a lot of errors: `ERROR: failed to start the concentrator`
Program try`s to restart and again errors.
Here is small copy-paste from journal:
>…
-
I have a RAK831 and I have used it on TTN with AS923. However, when I run `gateway-config` AS923 is not one of the options available.
Image version is `lora-gateway-os-full-raspberrypi3--2019081009…
-
I am using v2.3.1 of LMIC library and 0.5.2 of this library with MachineQ LoRaWAN service. I can see the Join MAC requests in the serial stream and the MachineQ sending a join accept. Yet, the device …