-
This blog appears to have an issue with burning out certain LEDs: https://blog.wildernesslabs.co/hack-kit-series-closer-look-at-relays/
The blog has you drive the relay to pass through a 3.3v load …
-
Hi there!
I started digging around with the intent to add chlorinator operating status to your library, but notice that some work has already been done in an attempt to add this, and wonder what yo…
-
I recently purchased an 8 relay board from ebay. I was super excited as it has everything I need for my project. However, I cannot upload a sketch to the Atmega328. What version of the Arduino IDE …
-
**Describe the bug**
When i have more then one LN882H device connected to my Unifi WiFi only the first connected one of them works, the others go in to a reboot cycle, despite being shown as connecte…
-
### The problem
I have updated my sonoff basic today.
After the update the sonoff was not available anymore in home assistant.
I bit the bullet and crammed it out the corner in order to reflash…
-
**Describe the bug**
I have a car with an 8chan wired up. If I control the main relay pin (meaning the main relay pin is assigned to Main Relay output), i connect usb, and I key on, the ECU hangs. If…
-
I am helping someone set up a pool controller.
We are trying to set up Generic devices for Temp. We can create the generic device. But when we go back in to edit it the save and delete buttons are…
-
### Discord Username
Arribe
### Bug Summary
Ran into trouble with the 3 electromagnets having enough holding power. The APU will hold until the green light is on. Then when moving the engine cran…
-
### The problem
Seems to be related to #573.
When I use on_time, to turn on a relay at 08:00:00, it happens that it doesn't trigger - sometimes. The funny thing is that the time is synchronized, a…
-
Hello @rstrouse, I have been working on the Sequent 16 Relay Hat in the I2cRelay.ts but using the 8 relay as a template I can’t seem to get the address’s correct. Excuse me as I am a newbie at GitHu…