-
Introducing re-meshing leads to additional synchronisation points and re-paritioning work.
To reduce this cost as much as possible, I suggest requiring adaptive meshes be tagged as such.
```xml
…
-
## Issue Details
As this picture shown, the inside surface of this hole is meshed badly;
So I want to remesh it, but only the inside surface.
The outside surface is simple, but enough, so i wan…
-
Hi all,
I have a quick question.
My problem starts with a rectangular domain, but it must have highly deformed boundaries on the top and bottom surfaces, as well as deforming inner nodes over ti…
-
We should
- [ ] deal with the fact that `Patch_id_pmap` may not have been initialized in the Polyhedron demo
- [ ] add vertices attached to constraints forming a sharp angle as constrained vertic…
-
We should have:
* Surface_mesh_remeshing
* Surface_mesh_corefinement
* Surface_mesh_repair
-
The current unittests are missing some aspects due to usage of the tube case:
- Multiple ModelParts
- Use of remeshing in Fluent (has failed for a long time, but was never detected)
- Two-phase f…
-
Hello everyone. Thanks for the nice work. I would appreciate your advice.
I am interested in developing meshes for axial slices of a brain domain. Ultimately, I would like to mark the subdomains as…
-
We have nearly everything available to make cashocs jobs restartable. Meshes can be read from saved state files and can (soon) be extracted to gmsh again. These can then be used to define a new initia…
-
We have the need to call a global reduction after mesh refinement, specifically, we are interested in the minimum `dx` (though in principle it could be recovered from parsing the entire mesh structure…
-
Yuchen is already using Matflow on the CSF and is simulating the compression of Al crystals.
When the volume elements are compressed by 60%, there is an error (which others get too) which results fro…