-
When heatbed scan aborts moveZ() if performed before homing to clear the nozzle from heatbed, that seems logical, but moveZ() breaks and do not move the bed if scan is aborted?
This may cause the n…
-
Generell ein großes Problem in der originalen Firmware ist das Z-Lift Layershifting.
Es passiert, wenn bei Retracts auch das Bett kurz runterfährt und wieder hoch.
http://www.rf1000.de/viewtopic.php…
-
If Feature Extended Buttons is deactivated, there will be errors during compiling (EEPROM.h)
#define FEATURE_EXTENDED_BUTTONS 0
`Arduino: 1.8.4 (Windows 7), Board: "Arduino/Genuino Meg…
ghost updated
5 years ago
-
In der aktuellen dev-Version gehen bei meinem RF1000 z.Z. folgende Funktionen nicht richtig:
- Homen der Z-Achse über G28 (ohne irgendwelche Parameter) funktioniert nicht richtig, das "retry" finde…
mhier updated
6 years ago
-
Frage:
https://github.com/RF1000community/Repetier-Firmware/commit/fb9207e51d411e11f53e725b53e2db6f8a502510
bezüglich
axisStepsPerMM[Z_AXIS]*-ENDSTOP_Z_BACK_MOVE * nHomeDir
Printer::ZEndstopUn…
-
Setup: Renkforce RF1000 3D-printer, PC is Win 8 64 bit running Repetierhost 1.0.6 and Slic3r 1.1.7, connected by USB to the printer.
The RF1000 has been converted to a dual extruder setup, defined in…
-
I have problems with the use of Advance_L and round objekts, perhaps of the small segments.
I am using a CoreXY (Sparkcube) with Repetier Firmware 1.0.3, a direct drive extruder and an e3dv6-Hotend…
-
Alter Thread: https://github.com/RF1000community/Repetier-Firmware/issues/129
Hier weiter wegen dem Z-Offset-Scan.
Natürlich können wir das Verhalten ändern!
Warum wurde das geändert:
Weil ich…
-
Alter Thread: https://github.com/RF1000community/Repetier-Firmware/issues/129
Wegen dem Homing.
Kann du mir evtl. ein Video machen, wie das aussieht?
Ich verstehe auch noch nicht ganz, wie ein…
-
kleiner Bug.
https://github.com/RF1000community/Repetier-Firmware/commit/a3950a1a6ddbf3bee59d92c6d4e6d0ba96c2a113
Danke @AtlonXP