-
Hello,
I configured juniper snmp, sflow and fastnetmon.conf with juniper ip and port.
When I try to run fastnetmon_client I do not see any traffic.
I configured same setting on other SNMP sflow pro…
-
**Scenario:**
Created VPN connection and need to setup BGP peering using the interface automatically created during the VPN creation process.
**FortiOS tunnel interface post VPN configuration (au…
-
Howdy!
In makefile there is a default target for executing tests:
```
make test
```
and it runs:
```
go test -short ./...
```
let's check what will happen if someone runs below (I did it l…
-
Hi,
I'm experiencing a similar behavior as #99 but for sflow. Looks like ipv6 destination are not supported as SFLOW destinations:
- Example config - *IPv6 encoded in brackets*:
```
! pmacctd c…
-
Currently, the `-l` switch outputs a nice CSV file containing the following columns:
`['sampleType', 'agentAddress', 'inputPort', 'outputPort', 'src_MAC', 'dst_MAC', 'ethernet_type', 'in_vlan', 'ou…
-
After restarting containerd via `sudo systemctl restart containerd`, I have pods stuck in various state (Terminating,Init, Running 0/1) indefinitely. Also, containerd is running but printing no logs a…
-
I installed pmacct (1.5.2) with default Ubuntu 16.04 repository. I try to write statistics using memory plugin
`cat /etc/pmacct/sfacctd.conf `
```
debug: true
daemonize: true
pidfile: /var/run/s…
-
This info is eating up my logfile.
How to turn down the logging level
Thank you
> # head -n 40 /var/log/fastnetmon.log
>
> 2016-08-22 22:15:49,265 [INFO] Logger initialized!
> 2016-08-22 22:15:49,2…
-
Hi All :-)
1. Problem: (Scaling)
Scaling doesn't work at all (--sample-rate with '@' or without makes no difference)
---> The Web-Interface have no scaling options too.
2. Problem: (Sampler Ra…
-
Hello
Tried to build pmacct on OpenBSD 6.1 and got the error in the title while building the _bgp_ target.
Full process (from ./configure onwards):
```
# ./configure
checking for a BSD-comp…