-
Hallo,
ich habe zwar geschaut, konnte aber nix finden, ob und wie man die Restreichweite einbinden kann, die ja bei evcc hinterlegt ist.
Ich habe kein We Connect , sondern einen OBD2 Dongle von me…
-
If it is modified to support ddsu666,
-
I have written an esp32 mbus scanner for reading the smartmeter of my energy provider.
It uses an mbus scanner attached to uart (from MikroElektronika).
That worked fine before the following was …
-
Commit 5772aa86be26aa148f4e51181b4be63586a46f55 introduces a bug on a newly programmed smartmeter-wifi with a fresh SPIFFS that makes it impossible to setup.
After entering the wifi credentials the…
-
After a reboot or when die IR-Reader isn't placed properly the automatic readout stops.
Once "Read meters manually" is initiated, the periodically readout starts again.
-
Hello,
I am running noderd on a raspberry pi 4 as docker container (as well as mosquitto, timescaledb and grafana). But I fail to get data from a smartmeter (sml) into nodered. The raspi is connect…
-
Hi,
the Node does not seem to be compatible with Node-RED 4.0. Is there a simple solution for this? Thank you.
-
There is an issue with the `node-red-contrib-smartmeter` (v0.6.3) module in combination with `node-red` (v3.1.0).
Inside the "Palette" view the module can be installed, but has a warning displayed.…
-
Unfortunately the Kostal smartmeter was not found by 'mbmd scan'.
192.168.0.30:502 -d kostal:71 is working. I found it in a forum.
-
Hi,
after updating Nodered from V2.2.3-12 to V3.1.3 in Docker (19.03.15) I could not more install the node-red-contrib-smartmeter V0.6.3
Docker is running on amd64 engine
Here the logfile:
> node-…