-
Are you planning to provide support for the ST32L151CCU6 microcontroller? Would this be very complicated to achieve?
I have found LoRa modules produced by Multitech hosting this microcontroller and…
-
Hi,
I am trying to flash a an STM32L151 using Stlink/v2 on a Mac with OSX Sierra.
I've installed stlink 1.3.1 using homebrew as explained in the readme. I am now trying to flash the device:
`…
-
# Problem
st-flash 1.2.0-134-gf80412c
2016-10-16T09:12:13 INFO common.c: Loading device parameters....
2016-10-16T09:12:13 INFO common.c: Device connected is: L1 Med-density device, id 0x10386416
201…
afnid updated
4 years ago
-
I want to run Libpredict on stm32l151 and i want to plot the position of satellite on the map, but the part of plotting is developed on python and so it can't be run on ARM MCU
-
Below is the output from running st-flash two times with a 10 second wait between the first and the second run, and nothing having changed. The first run gave errors, wrote full pages, ran in a little…
-
Hi,
I am using `STM32L152` and have enough ram to does not care memory usage. I couldn't dig the code enough yet but it is like the library sends buffer divided. I am using `u8g2_Setup_ssd1327_i2c…
-
in the lasted version of stlink with `stm32l100 discovery`:
Error: Data length doesn't have a 32 bit alignment: +2 byte.
older version is working fine (same board, same main.bin) :
OLDVERSION (http…
-
Hi Jorge and friends,
For various reasons I'm trying to use cortex-m-rt on a stm32l151 with a bootloader at 0x0800_0000.
This means my memory.x looks like this:
```
MEMORY
{
FLASH : ORIGIN =…
-
Hello,
It's possible to make a module that implements xtimer interface over an RTC to be able to wake-up the chip even from lowest power mode?
-
### Description
target : MTB_RAK811
toolchain: GCC_ARM
VREFINT_CAL_ADDR is resolved to a wrong address that result in a segfault. The correct address (working address) seems to be 0x1FF…
eskan updated
5 years ago