-
Hello. I do not know if this is the right approach, I've tried several and this is the closest yet. I'm still learning some of this stuff. I am driving a 4-dig 7-seg bar (common anode), and I have …
-
Hello Thomas,
As suggested I am opening an issue here to start the modifications required to the W1209 source files prior to doing a Travis CI build to get a binary that I can flash to my W1209.
…
-
Hi! Thanks a lot for your work! Can you add HC-12 radiomodule support. It based on STM8S003F3P6?
which has totally different pin mappings, and a different layout please see the
Readme.txt in th…
-
Thank you for your information on the W1209 and STM8S in general.
I just created my library for the w1209 board, and found that your table of LED segments has B and F reversed. On my board, B is A2…
-
I know this is general to all STM8 software, not just STM8eForth, but no reports could be found of people trying to run them below 2.95v.
I
VK6TT updated
4 years ago
-
Hi,
I am trying this library on my arduino nano, but I can see, that the PWM Frequency is ~500Hz.
But its supposed to be ~ 25kHz right ?
Am I missing something here ?
Best Regards
Stephan…
-
When I load my forth definitions via the console on the W1209-FD they are not being saved in the flash.
eg after a clean flash of W1209-FD binary
STM8eForth 2.2.21 ok
words
IRET SAVEC RESET R…
VK6TT updated
5 years ago
-
I was investigating various Forth implementations and noticed that [`