-
On page 21 of the 2024-05-02 version of Getting Started with Raspberry Pi Pico, under SWD Port wiring it says to connect GND(Pin 20) to SWD GND, GPIO24(Pin 18) to SWDIO and GPIO25(Pin 25) to SWCLK for…
-
What should I do after linking ESP32 to WIFI?
Should I connect my computer and ESP32 to the same network?
When I finished all this and wanted to link to SWD.local, EDGE reminded me like this——
…
-
I am stuck with the following screen state on rpi5:
``` sh
sudo openocd -f interface/raspberrypi-swd.cfg -f target/rp2040.cfg
Open On-Chip Debugger 0.11.0-g8e3c38f (2023-12-23-19:52)
Licensed unde…
-
On my hoverboard sideboards the SWD programming pins differ from the ones specified in [sideboard pinout](https://github.com/EmanuelFeru/hoverboard-sideboard-hack-GD/blob/master/docs/pictures/sideboar…
-
Serial Wire Debug (SWD) is a 2-pin (SWDIO/SWCLK) electrical alternative JTAG interface that has the same JTAG protocol on top.
It is highly recommended to use the SWD mode when the size of the circ…
-
Hi,
Since it should be fairly easy to get SWD being supported on CH347... any plan to release updates on OpenOCD sources?
Thanks 😄
-
Originally reported by: **Evolve (Bitbucket: [Evolveuwotm9](https://bitbucket.org/Evolveuwotm9), GitHub: Unknown)**
---
On retail, there was a well know spell delay which allowed you to do such stuf…
-
Hi!
It has previously been possible to upload to and run from SRAM on the older rp2040 but it seems no longer possible on the new sibling.
Is there any planned support in the pipeline or would i…
-
Open On-Chip Debugger 0.12.0-00024-g34afaa939 (2024-05-31-15:10) [https://github.com/STMicroelectronics/OpenOCD]
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/dox…
-
Seems that the DAPLink interface is not stable on my Muselab NanoESP32 S2 evalboard even if I set the adapter speed down to 1kHz, openocd log:
```
Info : Listening on port 6666 for tcl connections
…