-
Submitted by David Fulgham via the mailing list:
I've been experiencing an issue with our mesh network and mesh nodes repeating constantly. After some troubleshooting it looks like I may have come ac…
-
Using Terminal I installed your 2 dependencies and they say they installed successfully, however when launching xbar I get an error on the plugin,
ModuleNotFoundError: No module named 'aiohttp'
…
-
With the introduction of 802.11s, and the need to allow users to select if they want adhoc or 802.11s, we have been introduced with a new issue. Not all drivers support adhoc mode. The wizard should…
-
# UBNT
- device discovery
- device provisioning
- config archives
- config "diff"
- mass config changes
- firmware storage
- mass firmware upgrades
-
-
Running USG 3 with firmware 4.4.50.5272448
When trying to configure the wireguard interface for OSPF, eg. cost 20, the command fails with "vtysh-set command not found"
Looking at:
/opt/vyatta/share…
-
![The .deb will be gone soon, and the upgrades around 1.14 wouldn't work on non-UI hardware anyway](https://i.imgur.com/dSlWvZY.png)
If you use this Docker image, you'll likely never get an update …
-
### Describe the bug
Environment: MediaTek MT7628AN ver:1 eco:2 / GL-MT300N-V2 / OpenWrt 22.03.2 r19803-9a599fee93 / LuCI openwrt-22.03 branch git-22.339.35241-4ca7a8d
Hello,
I want to build …
-
Hi,
I've just tried the script on a UFiber Loco with firmware 4.3.0.
First run went flawlessly and changed the MAC Addresses of all interfaces in the Loco without issues.
All the runs after t…
-
For the life of me I can't seem to get this to work and am stuck - would appreciate any help.
Scenario - Site to Site VPN established using Unifi's open VPN feature and is tested as working. I logg…