-
This issue aims to list all USB requests:
* [ ] RNDIS (#506): networking over USB
* [ ] Library (#559): Extend USB class support using Pluggable USB from Arduino and providind more classe support.…
-
I purchased an IntelliKeys (IK) USB device from Ebay hoping to use it as a large touch surface. The IK USB interface is vendor specific so it is lot more complex than I expected. Fortunately, I found …
-
Hi! First of all, amazing work for this very welcome and needed functionality, especially on Linux systems.
I have tried getting my Mixxx library 'converted' to a rekordbox USB and all seemed succe…
-
Hello Kevin, thank you for developing this library.
I've a new RP2040-Zero connected to SN65HVD230 and a PCAN-USB interface with termination. I'm using very simple sketch to receive and send. I've…
-
My base board has been completely soldered (minus the screen. I have tried many times to flash the firmware from vscode but it is not working. It says the following: Verbose mode can be enabled via `-…
-
The UNIRAS rig will use an ethernet-based serial adaptor, [CSC-H64 by Sollae Systems](https://www.eztcp.com/en/products/csc-h64), in place of the current USB serial adaptors. This will require some (s…
-
I have downloaded and installed the SDK and canlib library.
And my Kvaser Leaf Light v2 module is connected like below:
 and the EFM8BB21F16G 4…
-
### Subject of the issue
Trouble using [USB_Host_Shield_2.0 library](https://github.com/felis/USB_Host_Shield_2.0)
### Your workbench
* RedBoard-Artemis-ATP w/ Sparkfun USB shield
* Sparkfun bo…
-
### Attention | توجه
- [X] I searched and no similar issues were found | جستجو کردم و هیچ گزارش مشابهی پیدا نشد
### What Happened? | چه اتفاقی افتاده؟
**Issue**: On macOS, after establishing a conn…