-
Hi!
Finally uploading worked :-)
Have connection via the Web interface, can change channels but if have no audio output.
Checked in conf the vs1053 settings:
pin_vs_cs = 5 …
apadt updated
9 months ago
-
Hello guys,
I wonder if it's possible to use codec WM8978 instead of VS1053 to play some music from the Internet. I asked this question to @SensorsIot on YouTube but unfortunately I think that he c…
-
ESP32 is not booting if VS1053 is connected to the amplifier and the volume is not set to minimum. If the volume is set to minimum all is good. ESP32 is wired directly with VS1053. Maybe I miss someth…
-
I re-downloaded the code and received a new error similar to last time.
Arduino: 1.8.19 (Windows Store 1.8.57.0) (Windows 10), Board: "DOIT ESP32 DEVKIT V1, 80MHz, 115200, None, Disabled"
c:/use…
-
Hi I have made my custom hardware where I am custom SPI pins to communicate with VS1053b chip and A TFT Display.
I am able to test my display properly but not able to run VS1053b.
I checked with l…
-
Hello.
I just tried to compile your code in arduino ide and got this error:
`\src\Adafruit_VS1053\Adafruit_VS1053.cpp: In function 'void feeder()':
\src\Adafruit_VS1053\Adafruit_VS1053.cpp:38:11:…
-
Hello,
I tried to build the whole device and then load software and SPIFFS image but on start the device on serial interface allways reports a lot of errors. All belongs to VS1053 and looks like:
D…
-
@peterbalch,
What a great and nice project.
I made it on a prototype board and it works great (have not connected the rotary encoder but stil very useful).
One problem I have: After a while t…
-
Hi, it's great project!
It plays well right after reset.
But it will stop when I change something (vol+-, station).
It will continue playing after disconnect and connect RST wire from VS1053. …
-
I have an ESP32-S3 Feather TFT, and an Adafruit Music Maker FeatherWing (VS1053) module.
I think I've sorted out the pins correctly (I verified with the [Music Maker pins documentation](https://lea…