-
This is a rare issue but has happened 3 times so far. I run Grbl in laser mode to engrave a picture. The file is large say 25Mb and is feed through streamer.py. After the job finishes I can sometimes …
-
Hi
why in Fusion the BER is very high ?
In DN mode the BER is around 15/20% , but it is lower using VM mode , I noticed also that after pushing the PTT I ear some seconds of tail with my last over .…
-
**Sugestion:**
It is pretty fresh project:
https://github.com/artlav/meteor_decoder
(with some precompiled binaries: http://orbides.org/page.php?id=1023)
Try it instead of "wine+lrpt offline dec…
ghost updated
7 years ago
-
Hi.
I get the following error message for `autorandr --change --force`, `autorandr --load jaque --force`.
```
$ autorandr --load jaque --force
Failed to apply profile 'jaque' (line 1343):
…
eseca updated
7 years ago
-
Startting Failure
C:\Users\XXX\Desktop\Sketch\libraries\arduino-lmic-master\src\lmic\radio.c 689
I have tried with 1.6.10, 1.6.11 and latest version of arduino.
radio.c code which i am using …
-
```
In 2.2.1, the SM, SP and TP commands were 'fixed' with regards to their
parameter, which (previously) was in units of 1/25KHz. The docs said
it should be in ms. So that was fixed in 2.2.1.
How…
-
```
In 2.2.1, the SM, SP and TP commands were 'fixed' with regards to their
parameter, which (previously) was in units of 1/25KHz. The docs said
it should be in ms. So that was fixed in 2.2.1.
How…
-
```
In 2.2.1, the SM, SP and TP commands were 'fixed' with regards to their
parameter, which (previously) was in units of 1/25KHz. The docs said
it should be in ms. So that was fixed in 2.2.1.
How…
-
```
The parameter for the SP and TP commands is being interpreted
incorrectly. It is effectively in units of 1/25KHz (40us) rather than 1ms as
the docs say.
```
Original issue reported on code.goo…
-
```
The parameter for the SP and TP commands is being interpreted
incorrectly. It is effectively in units of 1/25KHz (40us) rather than 1ms as
the docs say.
```
Original issue reported on code.goo…