-
### The problem
I use Flashforge Finder 3D Printer
And use FlashForge Plugin to use that
I do SD card printing.
So the problem is Flashforge Finder response to M27 is like below
SD printing b…
-
### The problem
While printing recently, it appears the MK3S+ spuriously detected a crash (there was nothing obviously wrong with the print when I eventually discovered this). Following a crash it a…
-
Issue with hotend heating on FF Dreamer using your pre-built v0.15.0 DREAMER_2.0.9.5_SWAP_10022022.BIN.
**First failure** - I receive "Heating Failed: E1 PRINTER HALTED Please Reset" - the same mes…
-
I am using Adventurer3X. (probably a Japan-only model)
When I set it up with this custom integration, the camera, print progress, and status entities were added, but the temperature and other sensors…
-
I have tried to access the I2c EEPROM that is actually on the same bus than the 9632 (SCL and SDA) pins PB1 & PF12 and it is numbered on the PCB as u203, and the 8pin soic/sop is labeled ATMLH428... (…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Of course, to use M149, TEMPERATURE_UNITS_SUPPORT must be define in Configuration.h
When u…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
When using the LED_PIN define for visual indication, the parts cooling fan changes state.
##…
-
Failed to flash, error message below
```
Start Control
Control Success
ok
Control Success
ok
Write file done
Writing to file 0:/sys/dreamer.bin Length 564464
ok
Failed to set trigger
Stop…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
In a scenario where there is a dual extruder with a single part cooling fan in a heated chamb…
-