-
I like to use Visual Micro because in many ways it works better.
However, it gets confused when I switch platforms on a project and ends up giving lots of errors. Seems more likely to happen on the…
-
`variant.cpp` line 36 has:
```c++
PB_5, //D5 D5
```
But according to the schematic D5 is connected to **PB_6**. and PB_5 is flash write protect (so should be one of the higher numbered d…
-
During uploading firmware, If USB interface -> "Enable USB device" option is selected. Then Catena 4551 radio resets continuously resetting while running in battery power. Same working fine with USB …
-
Dear all,
unfortunately my ttbeam (new) is not joing with OTAA on thethingsnetwork. I guess it is related to an timing issue as I tried with an "normal" ardunio sketch for the ttbeam and this works…
-
When I use the LMIC library with the 868 band configured in `lmic_project_config`, I get an error when I compile the ABP example. The error indicates that BAND_MILLI and BAND_CENTI are not configured…
BoelD updated
6 years ago
-
Although the code looks right, empirical measurements show that delayMicroseconds() is wrong for values in the sub 1ms range (much too long).
The following routine, if substituted in the OneWire li…
-
When I use the example sketch for OTAA, in combination with a Murata module, I can't get it working. In my gateway I do see an activation package coming in from the node. But then the activation never…
BoelD updated
6 years ago
-
Hi
Could this project support STM32 Core Arduino?
https://github.com/stm32duino/Arduino_Core_STM32
Thanks
-
We decided to overload `fHasLuxRohm` in the base flags; this was a mistake. I'm going to add `fHasLuxSi1133`. Long term, of course, we need a driver hierarchy rather than a flag bit. But that's a bigg…
-
We've defined extra platforms, but we don't have platforms defined, so they can't be referenced or configured.
Add the following GUIDs:
- `GUID_HW_CATENA_4450_M103()`, `{1fb2506f-0f2a-4310-9e6a…