-
Specs:
CC3D Running BF 2.9
http://www.johnny-robot.com/skytank250"]Johnny Robot Skytank 250
X4R-SB
3 esc's and 4 motors from eachine falcon 250
http://www.banggood.com/4-PCS-Eachine-Falcon-250-Flycolo…
-
I have attempted several times to load the latest version of Betaflight onto my quad. Everything seems fine in the Cleanflight configurator, but the ESCs won't stop beeping, won't sync, and the motors…
-
I am currently using this transmitter and 10 channel receiver via PPM input. I have access to Aux 1-4 and standard flight control. I am debating setup via the recently added iBus support in Cleanfligh…
-
I'm using the Taranis with the X4R-SB and I can only assign 6 aux channels. Even though I have channel 7 and 8 setup on my transmitter, cleanflight doesn't seem to be receiving the signal from the res…
-
Hi,
I'm very new to tunable quads but I think it would be a nice feature if the Adjustments would be saved even when they get disabled.
For example I did set up some in flight adjustments on differe…
-
Hi,
I have problem with this camera.
http://www.banggood.com/Eachine-CCD-700TVL-148-Degree-Lens-FPV-Camera-p-977401.html
Text from OSD is flickering. How to resolve this?
-
Hi, I have a problem with MinimOSD and Eachine 800TVL camera.
What happened is that I could see the video feed, but no overlay. If I unplugged the camera, I could see the overlay, but no video.
I che…
-
Hi.
I have a serious problem after upgrading from cleanflight v1.12 to cleanflight v1.13.0 out of the master tree. I flew with the default settings after firmware settings reset. All went ok, but afte…
-
- Seen in version (release version or githash): 2016-04-09
- On flight controller (if applicable): CC3D
Issue details:
I have an Eturbine TB250 (basically a metal Eachine 250 with some higher quality…
-
I just set up the 10ch Firmware V1.5 and found that end point configuration doesn't quite work as it used to.
On the first attempt the cursor would jump down the left column, then start on the right c…