-
I am looking at using a Seeed Studio XIAO ESP32-S3 for this ratgdo. Would that be a suitable board, or would it be best to stick with the ESP32 D1 Mini?
-
https://github.com/ratgdo/esphome-ratgdo/pull/88 added a work around for this problem but it would be nice to discover the root cause and revert the work around.
I didn't have enough time to bisect…
-
Is there a possibility to use a board that supports ethernet/POE?
-
Hello everyone,
I got some nodemcu 8266 laying around and I wanted to try this project. While I see it's for the D1 mini, I still flashed both 2.0 and 2.5 version of the 8266 and the flashing work,…
-
I have a jackshaft 8500C with a Yellow Learn button and 888LM wall panel.
I built a protoboard today following the latest schematics, I had gotten the IRLB8721 before it was know they were not suit…
-
I am seeing an issue and wondered if anyone saw this or what could be causing my issue. When I use an external power source for my Ratgdo, everything works properly. When I pull the 3.3v source from…
-
Hi,
After a motion event with the garage door opener that triggers the light to turn on (Example: motion or door open/close), the light will turn off after the defined configuration on the opener h…
-
## Expected Behavior
CurrentDoorState should handle OPENING, CLOSING, STOPPED states but only recognizes OPEN and CLOSED.
## Current Behavior
```
2023-12-30 09:55:20.746 [WARN ] [ssories.Hom…
-
-
Using the ratgdo shield with ESP8266 D1 Clone, flashing with the native MQTT, not ESPHome.
During setup, once the flash has complete and the wifi setup phase starts, the device connects to my netwo…
J-T-W updated
11 months ago