-
Hello. Unknown panel, resolution 104x52. Chips dp3216+2013ep. Raspberry 1. I just can't configure the image output. The best thing came out in the photo - half the lines at the top, half at the bottom…
-
Hi,
Anritsu spectum (MS8604A) analyzer (and some other equipment) have a "Separate video output" or VIdeo Output Separate".
This was supposed to be connected to a video (signal) printer (UA455A fr…
-
**Describe the bug**
With either `dtoverlay=disable-bt` or `dtoverlay=miniuart-bt` set in `usercfg.txt` (or `config.txt`) the bootloader does not initiate. After powering on the Pi, it is stuck a…
-
Hi,
I'm trying to set node-nrf on my RaspPi B+, and I can't get it work. The hardware is OK, I used the C++ example code to check:
```
pi@raspberrypi ~/nrf24l01 $ sudo ./rx
pi@raspberrypi ~/nrf24l01 …
-
Hello,
I commented in your streaming code, but i realize that this is the more appropriate folder to comment in. I have successfully gotten this code (rpi_adc_dma_test.c) to capture at 2.5Msamples/se…
-
Add warning when system temperature, voltage or averaged CPU exceeds limits.
This would allow users to diagnose some stability issues, especially when running video streaming
-
I recived a new testing prototype from RADXA with the print RA028_X1.0 (thanks @hipboi )
It's an 4 bay M.2 NVMe Hat that supports 2230, 2242, 2260,2280 NVMe's and is powered by a USB C port at 12 vo…
-
**Describe the bug**
Boot process intermittantly hangs during (or just after) start.elf stage when Mediatek MT7921K (Wi-Fi 6E module) is connected
**To reproduce**
Insert MT7921K Wi-Fi module and…
-
Hi every time I use the M102 S-1 or M119 Command klipper shuts down I'm using a CR10S Pro V2 swapping from a BLtouch
[klippy (2).log](https://github.com/markniu/Bed_Distance_sensor/files/1372927…
-
I have an ESP32 Devkit C board and a 2.4" TFT Shield with a red board color. The shield has pins on both sides: one side has parallel data and SD pins, and the other side has CS, RST, WR, RD, F_CS, an…