-
I have Arduino Nano, RFM95W 868Mhz and installed LowCostloRaGwGW and working ping-pong sketch :-). I was try with DHT22 and it works to. How to connect GPS module gy-gps6mv2 and send coordinates to …
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
In https://forum.freecad.org/viewtopic.php?t=87857 a problem is discussed with a missing c…
-
Raspberry Pico
How to determine which pins are used for SPI, and how to do this for SPI1. Are there any standard pins?
Same for I2C. Is there any API (with examples)?
-
I am stuck with the following screen state on rpi5:
``` sh
sudo openocd -f interface/raspberrypi-swd.cfg -f target/rp2040.cfg
Open On-Chip Debugger 0.11.0-g8e3c38f (2023-12-23-19:52)
Licensed unde…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues and checked the recent builds/commits
### What happened?
Hello. I have a Radeon VII graphic card and freshly insta…
-
**Describe the bug**
When uploading
```
Sketch uses 26688 bytes (20%) of program storage space. Maximum is 131072 bytes.
Global variables use 1652 bytes (4%) of dynamic memory, leaving 35212 byte…
gbr1 updated
2 months ago
-
After pushing a repository from Linux, I cannot pull it from Windows with cygwin because git gets stuck after:
$ git pull
Initializing Keybase... done.
-
Hi,
I've tried to use this but I get this error message
SPIFFS Error: esptool not found!
Setup is Windows 1.6.5
cloned repo from github
Repo is installed and works fine, and uploads sketches
Howe…
-
Ubuntu Linux 14.04.2
bluetooth rfcomm# does not show up as port for Serial Monitor in arduino 1.8.1
It does not up under Tools->Port. Only /dev/ttyACM0 shows up.
It's not just a refresh problem…
-
```
What steps will reproduce the problem?
1. Install SimpleOpenNI Version 1.96 on a Mac OS X 10.6.8
2. Run any Processing sketch
What is the expected output? What do you see instead?
I can not run…