-
Hi,
I don't read in the readme.md what hardware is needed to use this software.
Is this the original wifi stick or some other ?
-
Thank you for your code adaption. I tried as you suggested with the following configuration.
```
esphome:
name: esphome-web-fcaf73
friendly_name: esphome-web-fcaf73
esp8266:
board: esp…
rorso updated
3 months ago
-
hi,
I have made tests with the following setup:
- Loop (current dev)
- iPhone 5s (ios 12.4)
- Medtronic pump 522
- CGM (SG from Dexcom share)
- GNARL-code from 11.9.19
- GNARL-hardware (https…
-
### Hardware
ESP32, ESP32-C3
### Firmware version
2.4.5
### Application version
2.4.5
### What happened? What did you expect to happen?
Not sure if it's a bug but wifi signal is -91dBm (reporte…
-
Hi, I am trying to compile the software for the diy hardware for an TinyS3 board because of shortage of TinyPicos.
if i am trying to compile with the esp32 module v2.0.6 i get an error for every boa…
-
Hey all,
I've got this working on all my Mitsubishi heatpumps (mainly msz-ap20vg units), and it's working well. I'm using ESP-01, with breakout boards.
I notice that about once per second, the blu…
-
After installing all boards/libraries etc with new RPi OS upgrade everything works really smooth. The arduino IDE 1.8.19 runs well...
I can compile and upload for all my different boards except the U…
-
I recently bought an arducam mini 2MP, I connect it to my arduino uno R4 WIFI, I want to run the example code "ArduCAM_Mini_2MP_OV2640_functions", but when I want to compile, it says:
C:\Users\Acer\…
-
The LED connected to the WiFi module is misbehaving (i.e is constantly turned on) regardless of the WiFi Module's pin output.
DoD:
* Determine the cause of this defect (it is hardware/electrical r…
-
Not sure this project is still supported. I discovered ConfigurableFirmata from Gobots.io.
I attempted to use the Firmata Builder today with the following configuration:
- ESP8266 device
- WIF…