-
Hi,
I'm using 6lbr on RPi as edge router for Contiki based network (cc2650 motes) experiments as described here http://processors.wiki.ti.com/index.php/Cc26xx_sw_examples with the exception of wrapsix…
-
Hi,
I've started implementing support for the cc430f5137 chip and the em430f5137rf900 board: http://www.ti.com/tool/em430f5137rf900
Right now the blinking light examples run but it looks like it wil…
-
I'm looking for advice on how to debug mqtt connection from sensortag with "cc26xx-web-demo" connected to mesh network through Raspberry PI + devpack Sensortag (CC2650STK) "slip-radio" acting as 6Low…
-
Hello everyone,
I am now in a starting phase of a 6lowpan project.
I did exactly as the instruction from
http://processors.wiki.ti.com/index.php/Cc26xx_sw_examples
The compile was done and I can …
-
@JelmerT Jelmer, I've been thinking perhaps we should bump version number to 2.0 :smile: and open a pull on Contiki?
-
This is a question:
I read that 6lowpan ip address assignment has **dynamic, static and hybrid** (refer [here](http://www.embedded.com/electronics-blogs/embedded-cloud-talkers/4236873/How-to-setup-a-…
-
I am using the very-sleepy-demo on a CC2650 sensortag, as compiled from the very latest master branch of this repo. However when I run this code on the sensortag with a 3.3VDC power supply, it draws …
-
I tried to build Slip-Radio.bin for SmartRF06EB+CC2650EM by "make TARGET=srf06-cc26xx BOARD=srf06/cc26xx slip-radio.bin". However, it doesn't work after I connect it to my Raspberry Pi. Does anyone kn…
-
I have tried to build cc26xx-web-demo.bin for CC1350 SensorTag. I can see it is listed on 6lbr Sensors page. However, I cannot open its web page. I have no problem to open the web page using SmartRF0…
-
Hi guys!
When trying to build a program that uses cc26xxware's ROM_FlashProgram I first get a "implicitly defined function" error while building and a linker error after that.
Having looked through t…