-
We need the spindle Direction output to run our laser properly. Was there a technical reason that this output was not ported? We're looking at adding this functionality, but wondering if there are any…
-
I'm wondering if there is a reason why the spindle PWM was set up to use OCR4A for the top value instead of simply using the fixed 10bit timer/counter. I had been trying to change the PWM output pin f…
-
Hi All,
I am trying to
a) connect to a signal generator (Agilent N5182A MXG) that supports ASCII range(256) using TCPIP.
b) set a signal waveform to the signal generator (siggen) using IQ data
…
-
It appears I2C can only send out about 64 bytes at a time, and this is not documented as far as I can tell. I finally scoped my I2C bus with a Saleae when transmitting to the CY8C9560A (which requires…
ghost updated
6 years ago
-
```
__ __ _ ____ ____
| \/ (_) ___| ___ / ___|
| |\/| | \___ \ / _ \| |
| | | | |___) | (_) | |___
|_| |_|_|____/ \___/ \____|
MiSoC Bootloader
Copyright (c) 2017-2018 M…
-
### Module 2
- [x] Python’s “Itertools”
- [x] Data Structures (Part I): Introduction
- [x] Data Structures (Part II): Dictionaries
- [x] Data Structures (Part III): Sets & the Collections Module
…
rsokl updated
6 years ago
-
Control TBS Unify vtx channel / power selection via cli commands.
The use case is I have a quad with a fully enclosed TBS unify vtx with smart audio. I am running a pikoblx board and I do not have …
-
Creating and sharing pure typescript code has quite a few barriers that seem like the kind of complexity that TypeScript should be helping to alleviate.
I'm going through a situation right now where …
-
Moving from m-labs/artiq for now as this may be a hw issue.
@gkasprow:
- I remove the jumper on the programming connector to re-enable the RTM Exar chip, but left the 2V and 4V rails disconnected.…
-
Digital signal processing isn't my forte. Others have volunteered to come up with the best processing system for changing the PDM mic signal into PCM to be recorded to memory or SPI flash.
Right no…