-
This is a placeholder issue to cover an arduino/Arduino/issues/1476 improvement.
It looks like [arduino/ArduinoCore-avr](https://github.com/arduino/ArduinoCore-avr) repository is the correct one to…
-
The following circuit should be an error. Assumedly, this should be a verification hook added to either a FIRRTL circuit or to a module that is conditioned on it being the top module.
```scala
cir…
-
Related to #113 it would be practical to have a way of converting a gate to its logical equivalent based on De Morgan's Gate Equivalence. E.g. on an AND gate this could be done via right-click on the …
-
I installed NixOS from USB key in UEFI mode. There were a few things that were not clear to me from the installation instructions:
1. That I have to create a `boot` partition.
2. What is a reasonable …
-
Hello, I am the main developer of the RGB-Pi project to connect the Raspberry with CRT TVs through the DPI port, users would love to be able to use interlaced modes but I see that in the firmware this…
-
#### Which modpack version are you using?
2.0.9.0
#### If in multiplayer; On which server does this happen?
private server
#### What did you try to do, and what did you expect to happen?
…
-
The schematic in the readme is potentially dangerous for the RPI. You are mixing 5V logic (required for the relay board) with the 3.3V logic used by the RPI's GPIO. The power to energize the 5V coils …
-
We met and discussed the thread that follows below, and here at the top are some of the action items we came away with.
Per Jonathan:
- keep existing filter as is (don't touch)
- explore dynamic …
-
[Asynchronous circuit](https://avlsi.csl.yale.edu) based RISC-V implementations will likely use [data-dependent O(log log n) adders](https://avlsi.csl.yale.edu/~rajit/ps/async-case.pdf).
Why is the…
-
Request Z-Stack 3.x.0 coordinator firmware capable of Active mode TX at +10 dBm and +20 dBm RF output power on CC2652P and CC1352P based radios. Specifically request firmware preconfigured with 10 dBm…
Hedda updated
2 years ago