-
When trying to flash the SPI with the release files, I get an identifier mismatch:
```
*********
* ERROR *
*********
This is the installer for: [radxa-RockPi4]
The board detected is: …
-
**Describe the bug**
When I compile the hello_world example with the main version of Zephyr, the MCU crashes. This issue has arisen since a few days ago (transition to HAL5.1).
I'm using a custom …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Firmware failed to compile with SDSUPPORT turned on, otherwise compile successfully.
U…
-
Someone opened a case in openwrt for this issue but i think its firmware related problem and better here.
```
[ 10.127699] mt7986-wmac 18000000.wmac: HW/SW Version: 0x8a108a10, Build Time: 20220…
-
### Discussed in https://github.com/hathach/tinyusb/discussions/2034
Originally posted by **Jubatian** April 19, 2023
Hi,
Would like to ask about the behaviour of **tud_msc_read10_cb()** in…
-
There is a lot of information out there on ch341a programmer giving too much voltage (5v vs 3.3v). Users reports of having bricked their laptops (SPI chip to motherboards resistors).
One of those e…
-
### Describe the bug
Hi everyone, I have a mamba F722s MK2 flight controller, which I bought around 2019. I recently flashed the latest version of betaflight firmware and found that whenever the flig…
-
I'm using espflash master to flash a esp-idf-* (master) project with espflash to a esp32c6.
```
espflash flash --monitor
[2024-01-22T08:43:49Z INFO ] Serial port: '/dev/ttyACM0'
[2024-01-22T08:…
t-moe updated
2 months ago
-
I'm experiencing a double start of "code.py" with beta 1 when powering the board from USB.
My APA cycles through a rainbow in code.py and I can see it goes from red to blue then turns off and then …
-
Hi ,
Recently I got a sx1302 module with raspberry transfer board , I try to execute with compiling the open source sx1302_hal codes .I tried to test with test_loragw_reg , the result as follow …