-
I have wrong data without change any thing of installation, for exaple resistance of cell numer 1
LOG:
[0;38m[VV][jk_bms_ble:220]: Notification received: 00.00.00.00.00.00.00.00.00.FE.FF.7F.DC.…
-
### Describe the problem
I noticed that with one of the two connected BMS units, the 'cell voltages' disappear, thus halting the graph recording. After a restart, it works for a few hours again, then…
-
### Describe the problem
In my config.ini I've set MAX_VOLTAGE_TIME_SEC to 7200 (2 hours) - this is to allow time at max voltage for the balancer to work. As the curves are not uniform, top balancing…
-
Some of the values started to show ZERO value. They were working before and studently became zero.
JK BMS power / current / voltage / capacity / balance current / temperatures. Rest of parameters a…
-
Dear @syssi ,
my friend has the same BMS and esp as I have.
I have not any issue, but my friend has from BMS mischmash data about few days.
Before, all working fine, but few days ago, I was called …
-
I have 4 devices and when I need to config one of them I switch it off and on to connect to it with mobile apps, before after I close the mobile connection after some minutes it will show in batmon.
…
-
Hello, I tried to install as per the guide https://github.com/syssi/esphome-jk-bms/blob/main/esp32-example.yaml everything is installed correctly, using Raspberry p3+ usb module with FTDI chip and jk …
-
### Contact Details
_No response_
### VRM portal ID
b827eb6ff17f
### Country / region
Germany (de)
### B max
26
### TB max
6,5
### FB max
7
### TG max
30
### …
-
* Infer protocol version from bms version?
* Implement JK04
-
### Describe the problem
Cant get the serial interface get to work.
App About Section:
![Screenshot_2023-11-17-08-43-13-22_bd59be8c3f820c1e3d6fc2892aab342d](https://github.com/Louisvdw/dbus-seria…