-
I have had at least two instances of Print Scheduler starting another print right after non-scheduled print completed.
Steps to reproduce.
1. Use "M80" G-code action to turn on the printer (it f…
-
using generic 3.5 inch (http://www.lcdwiki.com/3.5inch_RPi_Display)
cmake commands:
$ cmake -DWAVESHARE35B_ILI9486=ON -DSPI_BUS_CLOCK_DIVISOR=30 -DDISPLAY_CROPPED_INSTEAD_OF_SCALING=ON -DDISPLAY_B…
-
Earlier this year I learned that Banana Pi and OpenWRT were teaming up to release a low cost wifi 6 router. The board is designed by OpenWRT and will be producted and marketed by Banana Pi. Here is an…
-
The Myriad resets due to `Slave not ready after 1000 ms` error. This leads to an SpicommInternalError exception and results in the Finally clause to execute in JoyDetector.run causing the application…
-
I have been attempting to run lesson01 but with a Raspberry Pi 4 Model B. Based on [this](https://www.raspberrypi.org/documentation/hardware/raspberrypi/bcm2711/rpi_DATA_2711_1p0.pdf) peripheral manua…
-
VC4 stopped working with upstream kernels after bd88f66f8952d34e4e0613a85c7a6d3da49e13e2. The VC4 modules load but VC4 does not work. This issue is the same with all upstream kernels I tried:
```
…
-
**Describe the bug**
Starting with Linux 5.1 there is a new power driver for BCM2835. The idea behind this is to have a better control about the V3D power domain. After rollout i got informed that so…
-
Hi!
I'm trying this example with another PHY - DP83848.
It works well with this example: https://github.com/sandeepmistry/pico-rmii-ethernet
It sends DHPC requests, i see it in wireshark and rout…
-
```
Hi,
please find attached the necessary files to use some familiar EEPROM chips.
Such chips are a part of the new HAT standard for RPi adapter boards.
This driver is implemented inspired by the …
-
```
Hi,
please find attached the necessary files to use some familiar EEPROM chips.
Such chips are a part of the new HAT standard for RPi adapter boards.
This driver is implemented inspired by the …