-
I tried most of the examples in the library including software SPI, TMC_AccelStepper and simple in the hope of getting the driver to move the motor but nothing worked.
my setup is the following:
- T…
-
Hi folks,
I have a big issue. I'm running dual E motors with a single nozzle (cyclops clone) and dual Z motors on a SKR 1.4 turbo, with five TMC5160 steppers, with a marlin bugfix 2.0.x SKR 1.4 FW.…
-
Hello! I'm running into some trouble with my CNC xPRO V5. I am unable to get the Z-Axis working. I have narrowed the problem down to the xPRO not outputting a signal to the Z motor. I know this becaus…
-
Hello, i'm having An issue when i upload Marlin 2 to my Skr2.0 revB with 2209 stepper drivers. Printer is a tronxy x5s corexy model. I can move all Axis, however X and Y only move diagonally. Corexy …
-
I am having difficulties using my TMC5160 v.1.2 drivers from bigtreetech with a v.1.0 RUMBA32 from Makerbase. I've tested many different builds of Marlin, and also the MK4duo firmware - all with the s…
-
Gotos dont consistently signal completion.
-
I have a Raspberry Pi 4B 8GB, installed and played a bit with LinuxCNC sim configurations, and I am ready to give remora a try for some CNC experiment. Which controller boards do you recommend me to o…
-
with the new version of jyers the nozzle temps extremely fluctuating between 190 -210 by an setted tem of 200.
i have done a pid tunnig , its done ok but after saving the fluctuating nozzle temp also…
-
From few days i have been trying to start dual endstop for Z line.
SKR 1.4 TURBO + TMC 2208 UART
All motors from all axis works.
Issue: when i try home positioning Z axis Z_MIN stops both Z driv…
-
Version: 0.3.8rc4
The Syntax Highlighting is pretty cool and thanks for your mission to get it perfect 👍
Some minor weirdness I noticed:
![grafik](https://user-images.githubuserconte…