-
I am building a printer for a customer and I want to make a cut-down version of the web interface. Right now I just want to remove the auto bed compensation section, because the printer needs to use g…
-
Hi David,I found that the On-Board SD Card didn't support Hot Plug(Duet 0.8.5).If I Pulg the SD Card,I must Reset the board.But I have checked the schematic and found that the Card Detect Pin has bee…
-
What I found on first read-through (without proofing the actual G-codes referenced):
Typo:
> Run the M665 and M665 commands and inspect the output:
Typo:
> To simplify recalibration you can so…
-
Hi David,
I'm playing with this amazing firmware on an Alligator board, I would like to take advantage of a network connection :)
Alligator has different ethernet PHY chip but it is compatible wit…
-
(Apologies for originally posting this in the Duet Wifi General forum - I just haven't been thinking very clearly today.)
My CoreXY printer was very stable with DuetWiFiFirmware-1.18beta1, but afte…
-
So the build script reads the following:
It then puts all the css into one file and minifys it. Why does reprap.htm not contain the non min version of the stylesheets? I would have pres…
-
Curious on the status of the closed loop code/update
I would like to test using Marlin on 8bit Rumba and on 32bit Duet Wifi running Repetier
-
An AJAX error has been reported, so the current session has been terminated.
Please check if your printer is still on and try to connect again.
Error reason: Not authorized.
Others have tried to reso…
-
I just switched to the DuetWIFI and am having some major trouble getting the printer to pay nice with my settings. This is to say these settings worked fine on the Duet 0.8.5
At the end of my config.…
-
I've seen several printers lately running dual X-carriages (mainly https://www.bcn3dtechnologies.com/en/catalog/bcn3d-sigma/). Advantages include no drooping from the inactive extruder and no dragging…