-
Hi ,
I am getting started with this platform, pretty interesting, I have setup up the server, connected the Multitech gateway in packet forwarder mode. I can see the gateway is connected on the se…
-
Hello,
I just started testing with the RFD900+ modem. However, I am unable to communicate with it via minicom. I typed +++ and AT1 but there was no response. I have attached the flash900.log file. Ho…
-
hii , I have set the gateway power to 30dBm. I wanted to know how does it exactly affects the gateway when I change it. I mean on the RAK831 gateway board which pins does it affect so it reduces or in…
-
Hi everyone!
Excuse me for my, a little bit stupid and, maybe, off-topic question...
I'm trying to understand in general, how to use the LoRa-Gateway project.
I'm already made a LoRa-node device PC…
-
Is it possible that the multi packet forwarder somehow loses connection to router and does not re-establish the connection without restarting the gateway?
I have “Last Seen 29 minutes ago” in gateway…
-
Hello. The document says
```
imme | bool | Send packet immediately (will ignore tmst & time)
tmst | number | Send packet on a certain timestamp value (will ignore time)
tmms | number | Send p…
-
I managed to get the system running and ran it say 5 times with no errors and was about to work out why the connection was not showing on the Things network when I got the error message "failed to sta…
-
We are having a clock issue with the packet forwarder.
The clock used for checking at the JIT queue appears to be non-sequential, but the clock attached to uplinks appears to be OK. This causes all d…
-
Hi,
I am currently trying to run the server with a Semtech gateway (picoCell) but I have some connection issues.
I launched the server, set the UDP port for listening in sys.config (used the same po…
-
Currently I am using Cisco gateway to connect with this server.
It was all fine for either gateway connection/ device joinAccept.
However, when it comes to receiving rxpk from devices(through ga…