-
```
I have optimus in my laptop enabled, and when i launch openhardware monitor,
nvidia card starts power on and off every second.
```
Original issue reported on code.google.com by `doc.bogd...@gmai…
-
```
I have optimus in my laptop enabled, and when i launch openhardware monitor,
nvidia card starts power on and off every second.
```
Original issue reported on code.google.com by `doc.bogd...@gmai…
-
```
I have optimus in my laptop enabled, and when i launch openhardware monitor,
nvidia card starts power on and off every second.
```
Original issue reported on code.google.com by `doc.bogd...@gmai…
-
```
I have optimus in my laptop enabled, and when i launch openhardware monitor,
nvidia card starts power on and off every second.
```
Original issue reported on code.google.com by `doc.bogd...@gmai…
-
I like the look of DonglePi. Great idea, great execution.
But, to decide whether to use it projects, I need to know the license it's provided under.
Specifically:
What license(s) are the software rel…
-
I have this board:
USB\VID_04D8&PID_FEAA&REV_0100
I can see the device in the device manager as the name: Pinguino Project
But not apear.
Spanish:
No aparece mi dispositivo en la lista.
![capture2](…
-
Sanguinololu, Gen7, OpenHardware.co.za controllers etc - several machines use the Gen7 bootloader on a ATmega 1284p
When trying to flash Hex using Cura it fails with unrecognised signature:
Protocol:…
ghost updated
10 years ago
-
Cut Depth still only inch
Margin still only inch
ghost updated
10 years ago
-
I developed my own controller: http://wiki.openhardware.co.za/index.php/OpenHardware.co.za_FrontPrint
Based on Gen7 with lots of improvements and I only recommend Repetier Firmware on my controller
…
ghost updated
10 years ago
-
Modified setup() to work with our I2C LCDs a bit better, also provides a bit more detail logging during startup to help troubleshoot where it gets stuck
void setup()
{
#if defined(ENABLE_POWER_ON_S…
ghost updated
10 years ago