-
Over-the-air-Updates of Ubisys S2 dual switches appear not to work correctly.
# Setup
* Z2M `1.14.0`
* Running as add-on in homeassistant
* MQTT discovery deactivated, no devices manuall…
-
# Bug Report
## What happened
After the device is successfully interviewed, any commands sent to it fail with: 'No network route (205))'.
## What did you expect to happen
Since it has joined the…
-
# Bug Report
## What happened
I have some ZigBee 3.0 modules(From EBYTE), and they use Private Cluster ID(0xFEB0) and Private Profile ID(0x0504). When I add it to the network (The module d…
-
## What happened
Zigbee2MQTT becomes unresponsive after a couple of days.
I have 66 devices and none are responding to commands nor updating state.
Z2M logs errors; set [device] failed for …
-
Trying to get the prototype of zig-a-zig-ah! CC2562R stick working with ZHA but I'm getting this error message
```
2020-05-07 00:09:14 INFO (MainThread) [zigpy_cc.uart] Connection made
2020-05-07 0…
-
# Bug Report
## What happened
When I try to **set** temperature on `SPZB0001` thermostat, this will show `zigbee2mqtt:error 2019-12-10T13:59:39: Publish 'set' 'current_heating_setpoint' to 'Jonn…
-
Has somebody tried cc2652r?
Has it a better range then cc2531?
Is it worth to switch to cc2652r?
There were some issues: see here: https://e2e.ti.com/support/wireless-connectivity/zigbee-and-thread…
-
# Bug Report
## What happened
I have been using Danalock for 3 months now and it has been working fine being connected to one of my CC2531 routers (specially after I changed the firmware o…
-
I'm using a bunch of Ubisys S2 in-wall switches for my lighting. They have two channels, and a few months ago I was happy that both of them reported their state to Z2M. Then I found, as the devicecoun…
-
# Bug Report
## What happened
The Gira LightLink loses connection to the coordinator after ~5 - 10 hours.
To reproduce: After roundabout 10h of no action the device is not longer connected …