-
I see that vpnc-scripts package is available in the feed, however I can't find vpnc package in it. I believe it is available in MIPSEL Entware.
Is it possible to include it into Entware-ARM?
Thanks!…
-
验证客户端，跳过的问题，这个要怎么解决呀？
TASK: [ppp-radiusclient | Enforce radiusclient is installed] *****************\*
skipping: [host1]
TASK: [ppp-radiusclient | upload radiusclient config] **********************…
-
改用证书后，由于0.8.6的config文件以及本项目的config文件中的session-control = true，会导致worker进程退出。
具体参见[http://bitinn.net/11084/#comment-452257]
-
在安装openconnect.yml时，ansible提示找不到libgnutls28-dev这个包。
查找了一下，发现这个包在wheezy-backports/main里。不知能不能在openconnect.yml先添加backports再从backports里安装？
如apt-get -t wheezy-backports install libgnutls28-dev
Thanks;)…
-
compiling this package in a clean build tree leads to different results
debian (and buildbots) : package seems to build fine
arch linux: package fails with
```
CCLD ocpasswd
ocpasswd.o: In functio…
-
Hi,
I heard there is a patch. I'd be interested in trying it out. Otherwise, I'd be interested to swap 2 Linksys WRT54GL for 1 more thoroughly supported wifi router.
Thanks in advance,
Malte
-
**0.9 DTLS works:**
2015-03-19 09:30 DTLS option X-DTLS-CipherSuite : AES128-SHA
2015-03-19 09:30 DTLS initialised. DPD 30, Keepalive 20
2015-03-19 09:30 Established DTLS connection (using GnuTLS). Ci…
-
I have an ocserv instance with route=default and ipv6-network/prefix correctly set. Connecting from Linux gives the right IP address and route, which I can route all IPv6 traffic through tunnel.
Howe…
-
我使用的是centos，在同一台服务器上安装ocserv和nginx，会冲突导致其中一个用不到。
将端口改为10444之后就可以了。
对端口不是很熟悉，是否可以考虑将默认的改为别的？
-
我用的 0.11，用了这么长时间，几乎每隔两天就出现这个情况。我之前提过 #11，后来去做了手动设置，不知道跟这有木有关系。出问题的时候不管如何重启 shadowvpn、chindns、dnsmasq 都不行正常工作，只好去换个服务器，我有两台服务器，所以就每隔两天换个 IP 就正常了。
能判断是哪里出了问题么，还是升级最新就好了？最新的 openwrt 还是要手动去配置么？