-
Hello, I am building a custom cnc and it is in the final stages of wiring and configuring. Unfortunately, I am running into an error that I have been unable to diagnose for a few nights now despite he…
-
I get the above message now and then, usually after some time of inactivity.
What is causing it? , nothing is near the endswitches.
Can it be reset from console ?
AndKe updated
4 years ago
-
We can make this integration very close to what HIK connect offer and what API allow us to do...
For example for PIRCAM sensor we can get picture from it:
GET /ISAPI/SecurityCP/pircam/picture/chan…
-
Hi,
I’m currently troubleshooting problems with my limit switches on my cnc machine. I’m getting this error for no apparent reason:
> [Error] An error was detected while sending 'X20Y-21Z-0.6I0J…
-
Hi There,
This is a terrific library (thank you!) and yy apologies if this is not in the correct location but I can't for the life of me figure out what my issue is. I'm using your DS3231_intalarm…
-
Hello, I'm having some issues with my homing with Universal G code Sender. I built a Bulkman Lead CNC 1515 with DM542t drivers and the arduino nano running 1.1h. After I home the machine, it comes bac…
-
## Feature description
- EVO192 supports alarm triggering in versions 7.15+
- SP/MG supports alarm triggering in versions 7.10+
Implement an MQTT endpoint to send a message to alarm.
-
Hello,
Homing the arduino uno cnc throwing error 6. It moves z axis few steps and throws error 6. all limit switches are wired correctly and are verified using bcnc setup wizard. Here is my configura…
-
### Describe the bug
**My Setup**
Victron Cerbo GX
Victron MPPT 250|100 Solar Charge Controller
Victron Multiplus-II 48/5000/70
Battery 1 - 280AH x18s LiFePo4, Daly 150A BMS, Parralel protection…
-
Hi , First off Thanks to GRBL Software Engineers for a great bit of Control Software
My Set Up : I am Running GRBL 1.1f on a Mega 2560 - Was Programmed using the Hex File Method.
I Connect to G…