-
I have an Arduino uno with a force sensor that when triggered turns a digital output pin on my board low. Since Arduino uno goes from 5V output I put the output through a voltage divider to match the…
-
Hi !
When I stumbled upon this project, it seemed to be exactly what I need.
.. now I realize the following, stating from the docs/datasheets:
"The TLC5947 is integrated with a 4-Mhz internal o…
-
This isn't an issue but more of a question or discussion topic.
I noticed that music playback through the TED generally has low volume (i.e. no speakers hooked up to the card's audio-out port). I …
-
Hello again.
It is possible to implement this type of schema for the boot-loader in the code?
![image](https://github.com/wagiminator/MCU-Flash-Tools/assets/39467683/5cfa2780-3084-470a-b8c6-046069…
-
LCD 128x64 dot matrix
- use MCD23017 for I2C input to control LCD12864
-
I have the original vexta stepper 5 phase 0.72degrees with the stepper driver http://www.orientalmotor.com/products/pdfs/opmanuals/HM-60042E.pdf It is the driver without the directional switch pins. I…
-
Excellent project!
I built V4 of the rgb to hdmi board and V3 of the analog 6 bit board and I tested with several versions of the firmware with
the same results. The versions were 20201126, 202105…
-
"double strike" basically refers to outputting a 480i image but not alternating fields between even and odd. This allows a console to be able to switch between interlaced and progressive mode without …
-
Does it work also as a ZX80?
Here you can see a nice trick that will do with 4 resistors in case!
https://sinclairzxworld.com/viewtopic.php?t=1329
-
This issue may be the same root-cause as #9 -- when RA-board is picked in the VARA-FM PTT settings, it reports "RA-Board device not found".