-
I believe 6A current rating at 48V is completely sufficient for most applications the board would be used with NEMA 23 motors.
-
As the subject says, with a 48V 750W battery, what value should I enter in "Battery power max (W)" in "Basic settings" when using a 500W motor?
Thank you
-
Als deel van de research, maak een lijst van opties met daarin mogelijkheden voor batterijen, laadregelaars, vermogensensoren, zonnepanelen. Deze lijst kan later uitegebreid worden indien nodig.
-
I have original PorMr POW-HVM6.2M-48V-N
And ESPhome shows Incorrect mode of sensor Charger Source Priority:
**Current incorrect mapping:**
CSO - utility first (should be solar first)
OSO - solar a…
-
Convertie van 48v naar 12v nodig om de solenoids aan te sturen. (slot schuifdeuren)
-
I’ve forked your repo to drive my 48 volt LL-S battery. It has 6 address switches instead of 4, and address 64 is special.
1) Initial effort will be to get my single battery online and displaying p…
-
(Hello, first of all I wanted to thank you for this fantastic work. I have flashed the WiFi device with ESPHome.
But I am unable to flash my .yaml below. I get the folloiwng error:)
(Failed confi…
-
Is there an alternative to MP1584EN-LF-Z, as it has a limited input voltage of 28V. I plan to run stepper motors at 48V.
-
Great project, thanks for your open source, I have a question, if I want to adjust the nominal voltage to 48V, continuous current to 12A, peak current to 40A, do you have any good suggestions?
-
y la8rat » Apr 06 2019 1:41am
casainho wrote: ↑Apr 06 2019 12:22am
la8rat wrote: ↑Apr 05 2019 7:37pm
i know we are out of space for new code on the ktlcd3, but on future displays it would be grea…