-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
\Atmega_Board_Programmer\Atmega_Board_Programmer\bootloader_atmega328.h:3:34: error: variable 'atmega328_optiboot' must be const in order to be put into read-only section by means of '__attribute__((p…
-
```
What steps will reproduce the problem?
1.Use Sanguino-0023r4 and arduino-0023 software to upload via USB to Atmega1284p
What is the expected output? Done Uploading
What do you see instead? avrdu…
-
I lost a day, because I experienced frequent resets on serial reads.
This did not occur on the pins of Serial1 only on Serial and EVEN on an empty sketch without Serial.begin just with a short blink o…
-
Hello,
I am trying to update the firmware of my Creality V1.1.4 board using Sanguino as an ATMEGA1284p board in Arduino. I've managed to burn a bootloader to the board, using an Arduino Uno, with …
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
```
Sanguino currently supports the ATmega644P and '644PA. It is straightforward
to add support for the ATmega644 and ATmega644A.
Part I: Update boards.txt with the following new definition for …
-
```
What steps will reproduce the problem?
1.Use Sanguino-0023r4 and arduino-0023 software to upload via USB to Atmega1284p
What is the expected output? Done Uploading
What do you see instead? avrdu…
-
```
What steps will reproduce the problem?
1.Use Sanguino-0023r4 and arduino-0023 software to upload via USB to Atmega1284p
What is the expected output? Done Uploading
What do you see instead? avrdu…
-
I have followed in detail Maniacbugs forum posting for developing on the ATMEGA1284, I checked all my hardware and made sure the oscillator was working, I checked all voltages. The hardware seems corr…