-
Hi,
I'm trying to design the driver stage for a 3ph BLDC, but my inductors are behaving oddly. Their current is resetting as though they've been removed from circuit, even though they haven't.
[…
-
Hi, I'm a complete noob. 👋🏻
I can't tell if any of the layouts are the one I have.
I was able to unlock the board and flash it from Keil but now I'm afraid to power it on due to not knowing whi…
-
Hi! according to Block Diagram.png you are using IRF512 transistors, but i've checked datasheet and these came in 100V maximum rating. I guess that commercial VFDs use IGBT transistors... Don't know.
…
-
DoD: PCB board that is able to handle:
- Single Stepper motor (4 wire)
- Single CAN communication
- Power in noisy automotive env (requirements pending, likely 12V @ 10A peak)
- STM32
Saved…
amzoo updated
3 years ago
-
Hi,
I have tried to enable the LCD code by de-commenting the IFDEF flag in config.h
`#define DEBUG_I2C_LCD`
After this the code does not compile.
I am at a bit of a loss as there are a lot of H…
-
TKoma updated
9 years ago
-
Hi I'm interested in running I2C commander which communicates with SimpleFOC driver boards.
Code [something like this](https://github.com/simplefoc/Arduino-FOC-drivers/tree/master/src/comms/i2c#con…
-
## My Board:
I have another board with another different layout 😅
### Layout of Board A (Master):
![PXL_20230308_235227882](https://user-images.githubusercontent.com/25057949/223879988-d608eebd-…
-
Hi there!
I noticed that the original fw lasted quite a bit longer on my v2.0 board with the same battery and the motors weren't getting so hot. (Before the conversion I got around 10km range, now …
-
Hello Misan,
Steppers are cheap and have much more torque than DC Motors in same size, can you add option to output Step/Dir signal?
I think it would be a great new feature.
Could you ad "bluepill"…